TVM Exit codes
If TVM exits with an arbitrary 16-bit unsigned integer exit_code
. exit_code
higher than 1, it is considered to be an error code, therefore an exit with such a code may cause the transaction to revert/bounce.
Standard exit codes
0
- Standard successful execution exit code.1
- Alternative successful execution exit code.2
- Stack underflow. Last op-code consumed more elements than there are on the stacks. 13
- Stack overflow. More values have been stored on a stack than allowed by this version of TVM.4
- Integer overflow. Integer does not fit into −2256 ≤ x < 2256 or a division by zero has occurred.5
- Integer out of expected range.6
- Invalid opcode. Instruction is unknown in the current TVM version.7
- Type check error. An argument to a primitive is of an incorrect value type. 18
- Cell overflow. Writing to builder is not possible since after operation there would be more than 1023 bits or 4 references.9
- Cell underflow. Read from slice primitive tried to read more bits or references than there are.10
- Dictionary error. Error during manipulation with dictionary (hashmaps).11
- Most oftenly caused by trying to call get-method whose id wasn't found in the code (missingmethod_id
modifier or wrong get-method name specified when trying to call it). In TVM docs its described as "Unknown error, may be thrown by user programs".12
- Thrown by TVM in situations deemed impossible.13
- Out of gas error. Thrown by TVM when the remaining gas becomes negative.32
- Action list is invalid. Set during action phase if c5 register after execution contains unparsable object.32
(the same as prev) - Method ID not found. Returned by TosLib during an attempt to execute non-existent get method.34
- Action is invalid or not supported. Set during action phase if current action cannot be applied.37
- Not enough TOS. Message sends too much TOS (or there is not enough TOS after deducting fees).38
- Not enough extra-currencies.-14
- It means out of gas error, same as13
. Negative, because it cannot be faked